These are the file requirements every card job goes through prepress with. A file that meets them prints as designed; a file that does not usually still prints, but with a surprise somewhere — a trimmed border, a shifted black, a font that substituted.
Bleed, trim and safe area
Add 3 mm of bleed on every side and extend every background to it. Keep text and any element that must survive the cut at least 4 mm inside the trim line. Do not draw a thin border close to the trim edge: a cutting tolerance of half a millimetre is invisible on a photograph and very visible on a rule.
Resolution and colour
Supply raster artwork at 300 dpi at final size, in CMYK. RGB files are converted for you, and fully saturated screen colours — electric blue, fluorescent green — cannot be reproduced in CMYK, so expect a shift on those. Supply black text as 100% K rather than a rich black mix, or it will look slightly soft and may register badly at small sizes.
Fonts and file format
Embed or outline every font. Supply a single PDF per card face and one for the back, or one multi-page PDF in deck order, and use PDF/X-4 where your application offers it. Keep the layers unflattened if you can; it makes a late correction a two-minute job instead of a rebuild.
Card backs
The back is its own file with its own bleed. A back that is one pixel off centre is the most noticeable defect in a finished deck, so centre the design on the template rather than on the artwork bounding box.
Build on the print-ready template for your size, and send anything unclear to us before you print — a proof is cheaper than a reprint.